I can get complete set ups for anyone interested.This is the electronic dizzy from the EN1.It is a direct swap to the EBs.(No spacers required,only some minor wire splicing)Set ups include dizzy,coil,module,condenser and wiring plugs.Anyone interested sent mail to hparts@shaw.ca

By H (24.70.95.205) on Sunday, December 14, 2003 - 10:59 am:

By Kdbaker (Kdbaker) (69.22.106.85) on Sunday, December 14, 2003 - 10:03 am:

I printed it and I can't read it, sorry. Thanks

By Luckyluciano (Luckyluciano) (68.104.196.30) on Saturday, December 13, 2003 - 07:38 am:

sorry my hand writting sucks

By Luckyluciano (Luckyluciano) (68.104.196.30) on Saturday, December 13, 2003 - 07:37 am:

i dont know if this will help you, but i made a simpler diagram a few years ago. :

By jms (198.26.123.37) on Wednesday, December 10, 2003 - 01:03 pm:

where is the ig. module located?

Ken I sold those headers to Roger, here look at this link he had a prob with them.

http://www.civic1200.com/discus/messages/1/5696.html?1069274825

By This might help (199.243.98.218) on Wednesday, December 10, 2003 - 10:17 am:

Check ths link might help you, It is about half way down the page.

http://www.1stgencivic.com/upgrades/EngineInfo3.htm

By farenheight101 (24.69.255.203) on Wednesday, December 10, 2003 - 09:54 am:

you need the ignition module out of the donor car or at least the same kind. Thats where the two wiresfrom the distributor plus 4 more go to. Theres a wiring diagram somewhere on the board. Use the keyword search to find it.

By Kdbaker (Kdbaker) (69.22.106.85) on Tuesday, December 09, 2003 - 07:24 pm:

Can anyone tell me how to do this conversion? I need to know where the two wires from the distributor go and can I use my coil? Do I need to use the vacuum lines? I have a distributor from an 83 Accord. Thank you all very much.